How do I connect my phone to my monocular?

Image-capture capabilities are integrated into several monoculars. Others include mounts that allow you to attach a smartphone or camera, significantly increasing your shooting options.

People often are confused and wonder how to connect the phone to a monocular. Henceforth in this article, we will teach you how to connect a phone to a monocular.

Not only this, but we have also acknowledged other frequently asked questions regarding using monoculars.

How do I connect my phone to my monocular?

Follow the below steps to connect the phone to the monocular-

Step – 1

Place the phone in the holder and use the horizontal knob to adjust the width.

Step – 2

Adjust the phone’s angle by directing the camera towards the adapter’s circular hole and adjusting the side knob.

Step – 3

Remove the wrist strap and fix the monocular with the tripod thread. Check that the monocular is steady when standing on a flat surface and that the tripod is attached completely.

Step – 4

Connect the monocular eyepiece to the smartphone holder using circular motions and secure the phone. The picture will be viewable via the phone’s camera, so you won’t need to bring your eye close to the monocular.

Step – 5

Open the camera and magnify the image to eliminate the dark edges, then adjust the focus dial ring to clear your eyesight.

How to clean & maintain the monocular

Follow the below steps to connect the phone to the monocular-

Step – 1: Read the Manual

Before cleaning, check the user’s manual closely to see whether the manufacturer advises specific tools or chemicals.

While many monoculars are tossed in the garbage without much consideration, the instructions will explain what not to use because different lens coatings react differently to cleaning solutions.

Because monoculars aren’t cheap, employing the wrong chemical can permanently damage the lenses, costing the user a new set.

Step – 2: Remove Any Dirt & Dust

Hold the monocular upside down and use the bristles of a lens cleaning pen to dislodge any light material, then delicately blow out the loose debris with canned air.

If you’re using canned air, make sure it has small bursts of air and don’t get too close to the lens because it will ice up.

While it may be tempting to clean off dust with a microfiber cloth, this might result in microscopic scratches, which can cause the images to become foggy over time.

Similarly, avoid breathing directly onto the lens since this can cause water spots that are difficult to remove once they have dried.

The EXO BarrierTM layer, which delivers improved resolution and light transmission, can be damaged if the proper cleaning utensil is not used.

Step – 3: Apply Cleaning Solution

Wipe away any leftover filth with a cotton swab dampened with water or a cleaning solution. It’s crucial not to pour the solution directly onto the lenses, as this could cause harm to the monocular ‘ internal components.

If the monoculars are waterproof, gently clean the lenses with a bit of spray of water. Monoculars should not be stored until they are completely dry.

Avoid cleaning the monoculars with window or glass cleaner because these solutions often contain chemicals that might harm the lenses’ integrity.

To avoid damage, consider the manufacturer’s advice before using any cleaning solution to the lenses.

Step – 4: Use a cloth

Once all dirt has been removed, wipe away any lingering smudges with the lens writing pad or lens cloth.

To clean the lenses consistently, apply light pressure and work in a circular motion. Ensure that this cloth is kept clean to avoid adding additional dirt to the lenses throughout the cleaning procedure.

While it may be tempting to clean monoculars with whatever fabric is closest at hand, stay away from clothing and paper towels.

These materials contain fibers that can damage lenses, perhaps removing the coatings.

How to use a monocular?  

A monocular is a tiny telescope. It’s smaller and lighter than binoculars, yet it’s just as powerful. When using a monocular, make sure you have a good grasp on it and that you hold it up to your eye.

Through the lens, you’ll be able to locate and track your target. Keep your monocular safe and clean while using it to get the most out of it.

Follow the below steps to use a monocular-

Step – 1: Use your dominant eye

It is critical to use the eye with the best vision if you have impaired vision. Even if you have normal vision, this can be beneficial. While using the monocular, place it against this eye.

Make sure you’re holding the monocular on the same side as your dominant eye.

Step – 2: Hold the monocular

Raise the monocular to your eye while maintaining a firm grasp on the barrel near the contact lens. Without actually contacting the eye, the lens should be as close to it as feasible.

To keep the monocular stable, close the other eye and put your forefinger against your brow. To keep your arm still, keep your elbow against your body.

Step – 3: Adjust the focus

Different types of monoculars have different adjustments. Some monoculars can be adjusted by twisting a ridged dial on the monocular with one finger.

Others necessitate using both hands. Rotate the dial in the opposite direction if the scene is becoming blurrier rather than clearer.


We hope you acknowledged how to connect a phone to the monocular. While bird watching, you can use only one hand to operate a monocular, allowing you to carry other essential items such as maps or tumblers.

You can also do other things, such as make a phone without disturbing your rare moments with nature. Monocular is the best gadget as far as effectiveness and portability are considered!!!

Related Topic: How do you use an iPhone on a monocular?

Leave a Comment